Home

Do It Yourself Water Heater Efficiency Tips

Home » Home & Energy Center » Do It Yourself » Water Heaters

Don’t take the comfort and convenience of having hot water in your home for granted. Use these do-it-yourself tips to help extend the life of your water heater, and save water and energy.

  • Lower water heating temperature – Although some manufacturers set water heater thermostats at 140ºF, most households usually only require them to be set at 120ºF, which also slows mineral buildup and corrosion in your water heater and pipes. Water heated at 140ºF also poses a safety hazard—scalding.
  • Drain a quart or more of water from your tank (until the water runs clear) every month or two to remove sediment that impedes heat transfer and lowers the efficiency of your water heater.
  • Savings resulting from turning down your water heater temperature are based on two components: reduced standby losses (heat lost from water heater into surrounding basement area); and consumption (from water demand or use in your home). Set too high, or at 140ºF, your water heater can waste anywhere from $36 to $61 annually in standby heat losses and more than $400 in demand losses.
  •  If you have a dishwasher without a booster heater, it may require a water temperature within a range of 130ºF to 140ºF for optimum cleaning. And while there is a very slight risk of promoting legionellae bacteria when hot water tanks are maintained at 120ºF, this level is still considered safe for the majority of the population. If you have a suppressed immune system or chronic respiratory disease, you may consider keeping your hot water tank at 140ºF. However, this high temperature significantly increases the risk of scalding. To minimize this risk, you can install mixing valves or other temperature-regulating devices on any taps used for washing or bathing.
  • Insulate hot water pipes – Insulating your hot water pipes reduces heat loss and can raise water temperature 2°F–4°F hotter than uninsulated pipes can deliver, allowing you to lower your water temperature setting. You also won’t have to wait as long for hot water when you turn on a faucet or showerhead, which helps conserve water.
  •  Paying for someone to insulate your pipes—as a project on its own—may not make economic sense. But having the insulation done during new construction of a home, during other work on your water heater or pipes, or insulating the pipes yourself, is well worth the effort. In special cases, such as when the fuel used for heating water is very expensive, the distance traveled by the pipes is far, the pipes are exposed to very cold air (in which case they should be insulated anyway to prevent freezing), and if the household uses a lot of water, much higher energy savings can be obtained. In these cases, cost savings may offset paying for someone to do the job for you.
  • Insulate your water heater tank – Just like insulating your walls or roof, insulating your hot water tank is an easy and inexpensive way to improve energy efficiency and save you money each month. If your water tank is new, it is likely already insulated. If you have an older hot water tank, check to see if it has insulation with an R-value of at least 24. If not, consider insulating your water tank, which could reduce standby heat losses by 25%–45% and save you about 4%–9% in water heating costs—and should pay for itself in about a year. You can find pre-cut jackets or blankets available from around $20.
  • If you don’t know your water heater tank’s R-value, touch it. A tank that is warm to the touch needs additional insulation.

Replace Your Water Heater to Avoid a Breakdown.

Water Heater Installations & Replacement

Professional Repairs from Certified Plumbers.

Water Heater Repairs

Save Energy All Year Round.

Get the most energy for your dollar all year with our seasonal tips.

Learn More

Request an Estimate.

We’ll help you find the right water heater for your home and budget.

Request An Estimate

Join our Email Club